Mark2 Software

Mark2 3D Printer

Documentation | BOM | Assembly | Electronics | Firmware Setup | Software Setup | Calibration | Printing | Troubleshooting | Sample Prints | Upgrades & Modifications

Getting Started

Printrun / Pronterface

• Download
• Open
• Quick explanation of settings

Slic3r

• Download
• Open
• Quick walkthrough of different slicing settings
• Profile for Mark2 Printer

Testing the Printer

Caution:

Make sure you have quick access to a means to rapidly disconnect the printer from power in case something goes wrong. Ideally, use a powerboard with an on/off switch, or have the power cable in a position where it can be quickly unplugged. Remember, safety first!

• Heat things up
• Test Endstops
• Move things around

Going Further

Simplify3D

• Profile for Mark2 Printer

Resources

http://reprap.org/wiki/RepRap_Options#CAM_Tools

http://www.pronterface.com/

http://slic3r.org/

https://ultimaker.com/en/products/cura-software

https://www.simplify3d.com/

http://octoprint.org/

https://github.com/guysoft/OctoPi