Difference between revisions of "Mark2 Calibration"

From Aus3D Wiki
Jump to: navigation, search
Line 1: Line 1:
 
[[Category:Mark2 Printer]]
 
[[Category:Mark2 Printer]]
 +
{{Mark2 Navigation}}
 
== Introduction ==
 
== Introduction ==
 
This page documents the steps that need to be taken to get your printer dialled in and calibrated for high-quality printing. It describes the most important steps, the things that you'll definitely need to do if you want to get good results - but there's a lot more info out there on the topic of calibration, and this guide can't cover it all. Check the [[#Resources | Resources]] section to see other guides on the topic.  
 
This page documents the steps that need to be taken to get your printer dialled in and calibrated for high-quality printing. It describes the most important steps, the things that you'll definitely need to do if you want to get good results - but there's a lot more info out there on the topic of calibration, and this guide can't cover it all. Check the [[#Resources | Resources]] section to see other guides on the topic.  

Revision as of 21:14, 9 September 2015


Mark2 3D Printer


Introduction

This page documents the steps that need to be taken to get your printer dialled in and calibrated for high-quality printing. It describes the most important steps, the things that you'll definitely need to do if you want to get good results - but there's a lot more info out there on the topic of calibration, and this guide can't cover it all. Check the Resources section to see other guides on the topic.

Temperature PID

Extruder Calibration

Z Offset

XYZ Axis Calibration

Resources

http://reprap.org/wiki/Calibration

http://reprap.org/wiki/Triffid_Hunter's_Calibration_Guide

http://prusaprinters.org/calculator/