Mark2 Calibration

From Aus3D Wiki
Revision as of 16:37, 9 September 2015 by Chris (talk | contribs) (Added page)
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to navigation Jump to search

Introduction

This page documents the steps that need to be taken to get your printer dialled in and calibrated for high-quality printing. It describes the most important steps, the things that you'll definitely need to do if you want to get good results - but there's a lot more info out there on the topic of calibration, and this guide can't cover it all. Check the Resources section to see other guides on the topic.

Temperature PID

Extruder Calibration

Z Offset

XYZ Axis Calibration

Resources

http://reprap.org/wiki/Calibration

http://reprap.org/wiki/Triffid_Hunter's_Calibration_Guide

http://prusaprinters.org/calculator/