Mark2 Troubleshooting

Mark2 3D Printer

Documentation | BOM | Assembly | Electronics | Firmware Setup | Software Setup | Calibration | Printing | Troubleshooting | Sample Prints | Upgrades & Modifications

Common Mistakes

None yet. What did you break?

Z Axis Binding / Vibrating

• X Axis spaced wrongly
• Z stepper driver current too low

How to get help

If you run into trouble, we'd be happy to do our best to help you out! You can contact us through the website.

One of the great things about 3D printing is that so many people are getting into it - there are a lot of other people out there who might be able to answer your questions. Here are a few good places to ask for a hand:

• http://forums.reprap.org/
• https://www.reddit.com/r/3Dprinting/

Other Troubleshooting Guides

General

http://reprap.org/wiki/Troubleshooting

http://reprap.org/wiki/The_incomplete_RepRap_Prusa_Mendel_beginner%27s_guide#CHAPTER_5.2C_TROUBLESHOOTING_GUIDE

https://reprapsquad.wordpress.com/reprap-squads-tips-n-tricks/

Print Quality

http://reprap.org/wiki/Print_Troubleshooting_Pictorial_Guide

http://reprap.org/wiki/A_list_of_common_problems