Difference between revisions of "Template:Mark2 Navigation"

From Aus3D Wiki
Jump to navigation Jump to search
(Remove development warning.)
 
(5 intermediate revisions by the same user not shown)
Line 1: Line 1:
<includeonly>
<includeonly>
{{Caution|Our Mark2 3D Printer is still under development, as are the wiki pages associated with it. Information on these pages is subject to frequent change, and may contain mistakes.}}
{{notice2|align=center|Mark2 3D Printer|<center>[[Mark2 Documentation | Documentation]] &#124; [[Mark2 BOM | BOM]] &#124; [[Mark2 Assembly | Assembly]] &#124; [[Mark2 Electronics Installation | Electronics]] &#124; [[Mark2 Firmware | Firmware Setup]] &#124; [[Mark2 Software | Software Setup]] &#124; [[Mark2 Calibration | Calibration]] &#124; [[Mark2 Printing | Printing]] &#124; [[Mark2 Troubleshooting | Troubleshooting]] &#124; [[Mark2 Prints | Sample Prints]] &#124; [[Mark2 Modifications | Upgrades & Modifications]]</center>}}
{{notice2|align=center|Mark2 3D Printer|<center>[[Mark2 Documentation | Documentation]] &#124; [[Mark2 Assembly | Assembly]] &#124; [[Mark2 Electronics Installation | Electronics]] &#124; [[Mark2 Firmware | Firmware Setup]] &#124; [[Mark2 Software | Software Setup]] &#124; [[Mark2 Calibration | Calibration]] &#124; [[Mark2 Printing | Printing]] &#124; [[Mark2 Troubleshooting | Troubleshooting]]</center>}}
</includeonly>
</includeonly>
<noinclude>
<noinclude>
[[Category:Template]]
[[Category:Template]]
</noinclude>
</noinclude>

Latest revision as of 22:51, 22 December 2015