Mark2 Software

From Aus3D Wiki

Revision as of 02:44, 11 September 2015 by Chris (talk | contribs) (→‎Testing the Printer)

(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)

Jump to navigation Jump to search

Mark2 3D Printer

Documentation | BOM | Assembly | Electronics | Firmware Setup | Software Setup | Calibration | Printing | Troubleshooting | Sample Prints | Upgrades & Modifications

Introduction

Getting Started

Printrun / Pronterface

Slic3r

Testing the Printer

Heat things up
Test Endstops
Move things around

Going Further

OctoPrint

Cura

Simplify3D

Resources

http://reprap.org/wiki/RepRap_Options#CAM_Tools

http://www.pronterface.com/

http://slic3r.org/

https://ultimaker.com/en/products/cura-software

https://www.simplify3d.com/

http://octoprint.org/

https://github.com/guysoft/OctoPi

Retrieved from "https://wiki.aus3d.com.au/index.php?title=Mark2_Software&oldid=101"

Mark2 Printer