Difference between revisions of "Mark2 Software"
Jump to navigation
Jump to search
(→Slic3r) |
|||
| Line 16: | Line 16: | ||
== Testing the Printer == | == Testing the Printer == | ||
{{Caution|Make sure you have quick access to a means to rapidly disconnect the printer from power in case something goes wrong. Ideally, use a powerboard with an on/off switch, or have the power cable in a position where it can be quickly unplugged. Remember, safety first!}} | {{Caution|Make sure you have quick access to a means to rapidly disconnect the printer from power in case something goes wrong. Ideally, use a powerboard with an on/off switch, or have the power cable in a position where it can be quickly unplugged. Remember, safety first!}} | ||
* Connect with Pronterface | |||
* Heat things up | * Heat things up | ||
* Test Endstops | * Test Endstops | ||
* Move things around | * Move things around | ||
* If something doesn't work, double check all connections (with power off). Check [[Mark2 Troubleshooting|troubleshooting]] page. | |||
== Going Further == | == Going Further == | ||
Revision as of 01:23, 13 September 2015
Mark2 3D Printer
Introduction
Getting Started
Printrun / Pronterface
- Download
- Open
- Quick explanation of settings
Slic3r
- Download
- Open
- Quick walkthrough of different slicing settings
- Profile for Mark2 Printer
Testing the Printer
 | Caution: | Make sure you have quick access to a means to rapidly disconnect the printer from power in case something goes wrong. Ideally, use a powerboard with an on/off switch, or have the power cable in a position where it can be quickly unplugged. Remember, safety first! |
- Connect with Pronterface
- Heat things up
- Test Endstops
- Move things around
- If something doesn't work, double check all connections (with power off). Check troubleshooting page.
Going Further
OctoPrint
Cura
Simplify3D
- Profile for Mark2 Printer
Resources
http://reprap.org/wiki/RepRap_Options#CAM_Tools